NetPassage WPE54AG firmware recovery procedure.
---------------------------------------------------
This procedure shows how to reload the firmware to WPE54AG should something goes wrong and the system could not startup properly. Should this happened, WPE54G automatically switch to loader  mode. The WPE54G  DIAG LED will light up and stays ON.
See table 1 below.

Table 1:
--------

   WPE54AG Operation state		     DIAG	
-----------------------------------------------------------------------
1) Loader mode, ready for tftp		 Blinking very fast     
   upload. 

2) Writing uploaded firmware to 
   flashrom.				  ON	

3) Writing to flashrom succcessful	  Blinking very slowly
------------------------------------------------------------------------


How to recover WPE54AG from failed firmware
==========================================
Before you start, after power ON router, check the DIAG LED status as described intable (1). 
Otherwise, WPE54AG isn't have this problem. If you experienced other problems
please call technical support for help.


1) Power OFF and disconnect WPE54AG from the network.

2) Connect one end of a MDI (cross-connect for WPE54AG ) cable to the LAN/WAN port 
   on the system then connect the other end to your computer LAN adapter.

4) Power ON WPE54AG then startup your computer. The computer will obtain an IP address,
   192.168.168.100 from the WPE54AG.

5) Insert the WPE54AG Product CD in CDROM then change directory to the  recovery folder.
   Double click on the batch file, w54agrcv.bat    

   OR 
   
   if manually execute the command, open a Command Prompt, change to the recovery
   folder in product CD and type the command below. Assuming CDROM is driver D. 
      
      D:\Recovery\TFTP -i 192.168.168.1 PUT image_name.IMG

    (image_name.IMG is the firmware image filename in the recovery disk.
  
   If you have downloaded a newer firmware and have it put in local hard disk
   e.g. in C:\wpe54ag\wp54gxxxx.IMG, then select this as your new path and firmware name.
   When the firmware image file is successfully transferred from your computer to the
   router, the DIAG LED will display as described in table 1.

6) Firmware restoration is now completed. Reboot WPE54AG and it is ready to operate.

				---------------------------------